OPERATION MANUAL
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 6
2 Assembly and installation of
the laminator
Assembly
of the stand
The stand consists of several parts which have to be assembled
after receiving the machine. To guarantee sufficient stability of
the stand securely tighten the connecting screws.
ATTENTION: Pay attention to the front and rear side of the
stand (see manual for the assembly of the stand)!
Unpacking of the
laminator
Remove the screws from the places marked with an arrow. Re-
move the lid of the box and lift the machine onto the stand.
ATTENTION: Make sure the stand is the correct way round
(front of machine on front of stand & rear of machine on rear
of stand)!
Installation of the
supply shaft holders
The holders for the top supply shaft (1) as well as the bottom
supply shaft (13) have to be installed after the installation of the
machine. Mount the holders according to the marking with the
letters „a“, „b“, „c“ and „d on the appropriate device on the ma-
chine.
ATTENTION: The holders have to be installed at the same
height to avoid the occurence of wrinkles during the working
process. For this purpose press down the holders with a
little pressure before screwing them tight!
Picture 1
Holders for the supply shafts
Connection to the electricity
network
Connect the machine to the electricity network by means of the
power plug.
ATTENTION: Be aware of the safety instructions!
