OPERATION MANUAL
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 11
6.
Continuous operation
: When selecting switch (7) to
“Continue“ the roller is driven continuously. The speed can be
adjusted with the speed regulator (6).
For safety reasons continuous working is only possible in the
forward mode and up to a max. board thickness of 12 mm.
This is secured by the safety light barrier. If the safety light bar-
rier stops the rollers it is necessary to switch over to “Step“ be-
fore continuous working is possible again.
7
. Backward operation
:
When selecting switch (8) to “Reversal“
the backwards mode is activated. By pressing the foot switch
the drive roller starts to move backwards.
ATTENTION: For safety reasons a continuous operation
in the backwards mode is not possible!
Warming-up of the top roller
Adjust the requested temperature with the temperature regulator
(5). The recommended temperature is 30-40°C. Switch over
switch (9) to “Hot” and wait until the control lamp (3) starts to
light.
ATTENTION: For an even warming-up the rollers should not
touch each other during the warm-up phase!