OPERATION MANUAL
6.3 Laminating
6.3.1 Laminating with the aid of working boards
6.3.1.1 Working with pre-cut laminates
Required materials
■
A laminating film (e.g. ProLam or AdLam)
■
A working board (see p.14)
Sequence
1. Adjust the pressure according to the thickness of the working
board (see p.12).
2. Cut the laminating film to the required size.
The film should be larger than the picture: approx. 3 cm at the
top and bottom and approx. 2 cm at each side.
3
.
Peel off approx. 2 - 3 cm of the cover paper (silicone re-
lease paper) of the laminate and fold it back to expose a
strip of adhesive.
4
.
Align the adhesive strip with the working board and fix it with a
little pressure.
5. Run the working board with the laminating film through the
rollers (by using the foot switch) so that approx. 1 cm of the
laminating film is fixed between the rollers.
6. Drape the laminating film over the top roller (6).
7. Continue to peel off the cover paper and fix it with a sticky tape
on the take-up unit (2) to assure an even removal
of the
silicone paper.
8. Lay the picture on the working board, align it and start with
the lamination process.
ADVICE: When laminating small pictures the silicone re-
lease paper can also be peeled-off by hand. To adhere
the silicone paper on the take-up unit (step 7) is not ne-
cessary!
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 18
