OPERATION MANUAL
6.2 Mounting
6.2.1 Mounting on pre-coated
substrates
Required materials
■
A mounting board (a substrate coated with double sided adhe-
sive film)
Sequence
1.
Adjust the pressure according to the thickness of the substrate
(see p.12).
2. Peel off approx. 2 - 3 cm of the cover paper (silicone
release paper) of the mounting board and fold it back to
expose a strip of adhesive.
3. Lay the picture on the substrate, position it over the folding
edge and align it with the top edge of the substrate.
4. Stick the leading edge of the print onto the exposed adhesive
strip.
ATTENTION: Do not apply too much pressure to stick the
picture onto the exposed adhesive. Too much and
irregular pressure can lead to wrinkling!
5. Push the mounting board with the tacked picture manually
between the rollers. To guarantee a proper fixation continue to
insert the picture and the board approx. 1 cm between the roll-
ers by using the foot switch (take care that the release liner is
not caught
between the rollers).
6. Drape the picture over the top roller (6).
7. Peel back the cover paper for further 30 cm.
8. Feed in the substrate slowly and start with the mounting
process. At the same time adjust the picture on the roller and
pull off the cover paper as evenly as possible.
ATTENTION: Take care that no dirt, for example dust,
comes in-between the picture and the mounting board!
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 15