SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.
l
h
a
t
s
w
s
@
o
f
n
i
:
l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Fig.2.5
10.
Cut the M12x1 thread for the bushing.
Before doing this, apply alcohol spirit to tap
and insert it into the drill guide bushing.
While tapping the thread the compressed
air flow at the adapter must be increased
so that no swarf can enter the combustion
chamber. During this work always wear
protective goggles (fig.2.5)
Note
:
Apply alcohol spirit to the cutting edges of the
thread tap.
Protective goggles must always be worn!
Screw taps and reamers in only by hand.
11.
Pull out centring sleeve and drill guide
bushing upwards, using the fitting /
removing tool.
Fig.2.6
12.
Clean the tapped hole again thoroughly.
Remove compressed air adapter and the
crankshaft locking tool.
13.
Screw the glow plug into the cylinder head
with the new threaded sleeve .noting the
specified tightening torque (Fig.2.6)
Fig.3.0
Remove the glow plug with the puller.
If it is held in its bore by carbonisation. use
puller (with clamping pliers)to pull it out (fig.3)
