1) SET TO MANUAL OPERATION
-
Disengage the drive gear by using the
triangular key and turning clockwise.
2) SET THE CLOSE LIMIT
- Push the gate to its fully closed position. Remove the screw
that holds the proximity sensor at the front end of the actuator. Slide it back so that the
back end of the sensor housing is 3-1/2” from the center of the drive carriage and re-
attach screw that secures sensor in place.
3) SET THE OPEN LIMIT
- Push the gate to its
fully open position. Remove the screw that holds
the proximity sensor closest to the actuator body.
Slide it forward so that the back end of the sensor
housing is 3-1/2” from the center of the drive
carriage and re-attach screw that secures sensor
in place.
3-1/2”
4) RE-ENGAGE THE MANUAL RELEASE
- Use triangular key and turn
counterclockwise to re-engage gears.
SETTI
NG
THE
LI
MI
TS
to the controller, it
3-1/
2”
11
SETTING THE OPEN LIMITS
1
2
CHIUDI
CLOSE
FERME
ÖFFNEN
CERRAR
SLUITEN
CHIUDI
CLOSE
FERME
ÖFFNEN
CERRAR
SLUITEN
3
4
1
2
1
2
CHIUDI
CLOSE
FERME
ÖFFNEN
CERRAR
SLUITEN
CHIUDI
CLOSE
FERME
ÖFFNEN
CERRAR
SLUITEN
3
1
2
Set to manual operation
disengage the drive gear by using the key
and turning clockwise
Remove cover plate and slide off cover
Push the gate to its fully closed position
Loosen two bolts and slide the micro switch
limit cam up against stop. Tighten two bolts