19
Notice
• The program cannot be memorize while the motor handpiece is in motion
• The program is not memorized unless the PROGRAM key is held down for more
than one second.
• If the program number is changed by the PROGRAM key, the initially memorized
preset values will be replaced.
5.6 After Use
When the treatment is completed, return the motor handpiece to the handpiece stand
and hold down the POWER key for more than one second to turn off the power.
• Auto Power Off
If the key is not operated or approximately 10 minutes passes during rotation with
no-load, the power is automatically turned OFF to save energy and prevent inn proper
operation. However, if load is applied during rotation of the motor hand piece, the
power is not turned OFF even during.
• Last Memory
The last setting used before the power is turned OFF is memorized. The setting when
the power is turned ON next is as that immediately used before the power has been
turned OFF.
6. Convenient Function
6.1 Program
You can change any preset values and have them memorized to your desired settings
(rotation speed, torque limit value, gear ratio and auto reverse mode)
1. Press the PROgRAM key until it turns to the program number which you want to
have memorized (up to 5 programs)
2. Adjust the rotation speed, torque limit value, gear ratio and auto reverse mode by +/-
key according to your needs.
3. Hold down the PROgRAM key for more than one second. When the alarm sounds
the settings have been memorized.