TECHNICAL
BETTCHER
LARGE MODULAR SERIES II WHIZARD
MANUAL
INDUSTRIES, INC.
REV. June 28, 2012
Page 15
8.2 Handle - Assembly And Adjustment (Continued)
WARNING
SHARP
BLADES
MAY
CAUSE
CUT
INJURY!
WHILE
WEARING
A
PROTECTIVE
GLOVE,
ALWAYS
CHECK
TO
ENSURE
THAT
THE
BLADE
IS
FREE
TO
ROTATE
IN
THE
MACHINE
PRIOR
TO
STARTING.
IF
THE
BLADE
DOES
NOT
ROTATE,
IT
MAY
CAUSE
THE
HANDPIECE
TO
ROTATE
IN
THE
HAND.
With the handpiece held in your operating hand, stand at your normal work position and
move your hand and the handpiece over your normal work area to check that there are no
binds or sharp bends in the flex shaft and casing assembly.
With your other hand, turn on the motor switch. While the blade is rotating, press the
rubber cap of the grease cup on the handpiece with your thumb. Press only until a light
coating of lubricant appears on the blade in the gear tooth area.
During daily use, the grease cup rubber cap should be depressed every 30 minutes. Refill
when empty.
WHIZARD
SPECIAL GREASE COMPLIES WITH
USDA H1 STANDARDS FOR USE IN FEDERALLY
INSPECTED MEAT AND POULTRY PLANTS AND IS
AUTHORIZED BY AGRICULTURE AND AGRI-FOOD CANADA
FOR USE IN FOOD PLANTS.
DO NOT USE A SUBSTITUTE TYPE LUBRICANT.
USE OF SUBSTITUTE LUBRICANTS COULD
RESULT IN DAMAGE TO THE UNIT.
Prior to placing the tool in operation, refer to the guidelines for tool adjustment and handle
size selection. It is critical to use the proper size handle and that the tool be properly
adjusted in order to gain the full benefit of the
Modular Series II Whizard
tool
design
concept.
You are now ready to put the Modular Series II Whizard® tool into operation.
Summary of Contents for 1000M2
Page 6: ......
