38
82.490 - Raptor
6.6. RINSING TANK
•
The rinsing tank (3) (figure 17) is located in front of the main tank.
•
It is ESSENTIAL for the rinsing tank to be filled with clean water, through the lid (1), without any pressure.
•
Its fill level is indicated by a clear gauge (2) which is visible from the self-propelled sprayer cab.
6.7. RINSING THE MAIN TANK
•
The rinsing balls (4) (figure 18) installed inside the tank, on either side of the gauge tube, ensure this function
(refer to the various rinsing phases, page 30).
6.8. HEIGHT AND SLOPE INDEXES
•
The slop (8) and height (7) indexes are visible from inside the self-propelled sprayer cab (figure 20).
6.9. LADDER
FROM THE CAB
(figure 19)
•
2 actions required:
- Begin by setting the parking brake by turning the switch (6).
- Then actuate switch (5), located below the handwheel, to lower the ladder.
ON THE GROUND
(figure 21)
•
To lower it:
- Pull the cord (9) and grab the ladder as it descends.
•
To raise it:
- Manually tip the ladder until it locks.
6.10. HEIGHT OF THE BOOM
•
A working height between 50 cm and 60 cm above the surface treated is recommended. This height is defined
by the nozzle spray angle and spacing.
•
There is a risk of drift with greater heights.
Summary of Contents for RAPTOR 2540
