BERTHOLD TECHNOLOGIES LB 567, User Manual

Page: 153 / 186

Chapter 7. Calibration Conveyor Belt/Chute
MicroPolar 2 (++) LB 567
57
7.2 Sampling
Before sampling, you have to enable the desired compensation
inputs and check the calibration Only the measured values of the
activated inputs are stored in the sample table.
If the measuring system is not yet in the measurement mode,
start the measurement now.
Push
RUN
to start the measuring system.
Push .
√ . to confirm the safety prompt and the device
switches to the measurement mode.
Watch the behavior of the microwave measurement with run-
ning full and empty belt, especially Sigma and Phi(fm) to en-
sure that not too many measurements will be rejected with
empty belt or with maximum belt load.
Check before sampling whether all available compensation de-
vices (e.g. height sensor, belt weigher) have been parameter-
ized correctly via the analog inputs. Watch and check the com-
pensation signals also with running full and empty belt, for
example in the live display.
The display to the left appears if you push
RUN
.
Note:
Push the
SAMPLE
button to start measurement of the raw
data. At the same time, the laboratory sample has to be taken
and marked. The analysis may be performed later, provided the
product is not changed by this.
Sampling is in process......
Push the .
X . button to stop the sampling process any time..
1 | - | LB 567 | 07.05 – 13:25
Live Display
Diagnostic
Setup
Access Level User Mode
Language English
RUN ▲ ▼ ►
1 | - | Start / Stop | 07.05 –13:25
Switch operating mode?
.. X .. .. √ ..
1 | - | Live Display | 07.05 – 13:25
Concentration av.
65.50
%
Conc. av. Conc. act. 64.35%
ESC SAMPLE .. ▲▼ .. ZOOM
1 | - | Live Display | 07.05 – 13:25
Taking Sample #1
Conc av. Conc act 64.35%
..
X .. . ▲▼ .