Bernina Record 830, Manual

Page: 123 / 212

123
Preparation
Preparing to Embroider
Threading the Bobbin
Embroidery Foot No. 26
to embroider attach presser foot No. 26 to the embroi- ►
dery computer and raise the presser foot
Embroidery Needle
depending on the embroidery thread, use a no. 75 to ►
no. 90 needle
special embroidery or Metafil needles for embroidery
►
with metallic threads
use a needle which is not damaged
►
raise the needle ►
Straight Stitch Plate (Optional Accessory)
the straight stitch plate has a small needle hole. The ►
needle insertion area (interlocking of upper and lower
thread) is limited and the stitching therefore optimized
for nicer results
remove standard stitch plate and replace it with the
►
straight stitch plate
pull thread to the right through slit ► A and to the left under
the spring
hold thread in curve of bobbin-case stop and guide
►
along edge, holding far to the right, until it catches
guide thread to left, pull over thread cutter
► B and cut off
A
B
Check the threading path
After threading the hook, hold the mirror under the
swung-out hook unit as shown in the pictures below.
Position of bobbin thread when threaded for embroidery ►