Bergstrom NITE Phoenix T2000, Installation Manual

Page: 68 / 72

68
5-3
To enter SERVICE MODE: Push both the ON/OFF and
ENTER button simultaneously at any time.
Display will show service indicator and a code 00
unless a fault has occurred. If there is an active fault
the display will show it as 01, 02, etc. Use up and
down arrows to scroll through the Fault Codes. See
SSI diagnostics guides for all definitions. These vary
by system.
1) Evap sensor open or shorted high
2) Evap sensor shorted low
3) High pressure switch open or shorted high
Press the ENTER button to proceed through the
available service screens. Use up/down arrows to
scroll through voltages and amps.
1) SV = Starting batteries Voltage
2) AV = Auxiliary batteries Voltage
3) AA = Unit Amperage draw
Pressing ENTER arrow after viewing service screen
will return you to the fault code screen.
Pressing the ON/OFF button will return you to the
Temperature Display screen.
When necessary, Check Filter light will notify you that
the filter must be cleaned or changed. To reset filter: at
screen 1 press and hold enter button for 3 seconds.
Enter
ENTER
On/Off
Operating Instructions