Bergstrom NITE Phoenix T2000, Installation Manual

Page: 54 / 72

54
B
A
C
3-8
18
19
Espar Heater Install
Finish Intake and Exhaust Hose
Installation
First, attach intake air tube to truck
structure with zip ties. Put cap on bottom of
intake tube. Next, run exhaust hose to the
back of cab, attach with clamps to the
structure of the truck. Cut off excess
exhaust hose, and place End Sleeve on the
end of the hose.
WARNING: HOT
– Keep exhaust hose
away from wiring or flammable material.
Make sure exhaust exits behind the vehicle.
Assemble the Fuel Pump Mount and
Hoses
Take rubber mount bushing and L bracket
and put them together to make mounting
bracket for fuel pump. Slide fuel pump into
rubber bushing (A). Take plastic caps off
both ends of fuel pump. Attach large fuel
hose to larger diameter end (B), figure out
length needed to connect to pick up tube
and cut off excess. Secure with clamp.
Attach small precut hose to smaller
diameter end of the fuel pump and secure
with clamp (C).
NOTE: Bracket shown in photo (B) will
always set the fuel pump at the desired
angle. Make sure the inlet of the fuel pump
is down.