Bergstrom NITE Phoenix T2000, Installation Manual

Page: 39 / 72

39
2-15
24
25
A
B
Electrical Installation
Run Cables from Truck Batteries
Loom 2 full length battery cables, 1 red and
1 black. The red (positive) cable will
connect the truck starting batteries positive
post to the (start) post (A) of the battery
separator.
You must use the provided 90
degree battery terminal end at the Terra
Power separator rotated to the center of
the switch.
Torque specs for separator terminals 88
(recommended) to 132 (maximum) inch
lbs.
The black (negative) will connect the truck
(negative) to the threaded stud (D) of the
BMS.
Connect NITE Batteries to the Battery
Separator
Using red battery cable, measure and cut to
proper length. Crimp ring terminals and
heat shrink. Connect one end to the most
appropriate positive (+) terminal of the
NITE
Batteries. Connect the other end to the
AUXILIARY terminal (B) of the battery
separator. See top photo.
You must use
the provided 90 degree battery terminal
end at the separator rotated to the
center of the switch
Install the Separator Assembly
Torque the Battery Cable Connections
Install the cover assembly on the enclosure.
D
26
27