Bergstrom NITE Phoenix T2000, Installation Manual

Page: 52 / 72

52
3-6
A
B
14
15
16
Espar Heater Install
Attach Heat Line to Sleeper Vent
Take the black metallic flex tube, measure
and cut length to run from heater unit to
louver/vent opening (A). Place two clamps
over ends of tube, and clamp tube to
heating unit and louver. Tighten clamps
securely but do not over tighten. Snap
Intake Grill onto intake end of heater (B).
Keep this area clear of debris or install
return air hose.
Attach Wiring Harness
Attach plug end of wiring harness into
wiring plug at bottom of heating unit. Be
sure the lock-in pin seats securely.
Run Power and Fuel Pump Wires
Through Floor
Run the power wire and fuel pump power
wire through the grommet (installed in
section 1) to the underside of the truck. If
the fuel pump wire will not reach using this
grommet, use the rubber grommet supplied
with the heater and drill a second hole.