Translated user manual (EN-V1)
BENOMIC S500
39 / 57
Problem C :
The work platform will not raise/lower.
Cause C :
Lift-system sensor not activated/defective
Solution
:
Withdraw lifter system fully or check sensor
Batteries empty
(Red LEDs on battery status indicator and 2x cyclic bleeps)
Charge batteries
Battery terminals make poor contact
Clean the battery terminals, remount the terminals
Key switch is off
Enable key switch (set vertical)
Emergency stop pressed
Release emergency stop (turn / pull out)
Overloaded
Reduce load. (see 10. Specifications)
insufficient hydraulic fluid
Replenish hydraulic fluid (scissors up, supplier information)
Switch/button faulty
Try the scissor-control service button next to the main switch
80 A fuse defective.
Consult your dealer
6.3 A control circuit fuse defective.
Consult your dealer
Stabilizers not extended
Extend the stabilizers far enough for extra support
Problem D :
The lifter system won't go out/in.
Cause D :
The work platform is too high
Solution
:
Lower the work platform to the lowest position
The BENOMIC S500 is on the pipes
Drive the trolley off of the pipes
Batteries empty
(Red LEDs on battery status indicator and 2x cyclic bleeps)
Charge batteries
Battery terminals have poor contact
Clean the battery terminals, remount the terminals
Key switch is off
Enable key switch (set vertical)
Emergency stop pressed
Release emergency stop (turn / pull out)
Insufficient hydraulic fluid
Replenish hydraulic fluid (scissors up, supplier information)
Switch/button faulty
Try the scissors control service button next to the main switch
80 A fuse defective.
Consult your dealer
6.3 A control circuit fuse defective.
Consult your dealer
