Translated user manual (EN-V1)
BENOMIC S500
21 / 57
6.
Transport
6.1
External transport
Please follow the procedure set out below if you need to transport the
BENOMIC S500
:
1. Lower the platform completely.
2. Make sure the lift-wheels are retracted, so that the trolley is resting on its flange
rollers.
3. Set the direction and speed control to position 0.
4. Switch off the
BENOMIC S500
with the main switch (turn the red key to the
horizontal
position).
5. Properly secure the
BENOMIC S500
to prevent it from sliding, rolling or toppling
over.
6. Ensure that the
BENOMIC S500
remains dry and frost-free during transportation.
7. After having arrived at its destination, the
BENOMIC S500
must be started up in
accordance with the points described in chapter 7.1.
6.2
Internal transport
The
BENOMIC S500
may also be transported indoors (in the greenhouse). The preferred
method here is to drive the trolley on its flange wheels or lift-wheels (see 8.2), but it can
also be moved with a forklift. To move it with a forklift, proceed as follows:
1. Lower the platform fully.
2. The lift-wheels are retracted, so that the trolley is resting on the flange rollers.
3. Switch off the
BENOMIC S500
with the main switch (turn the red key to the
horizontal position).
4. Position the forklift forks as far apart as possible and insert them as far as possible
under the trolley, keeping them centred.
5. On the other side, check that the forks protrude far enough and are positioned
centrally under
the BENOMIC S500.
6. Secure the
BENOMIC S500
to the load backrest on the forklift truck, so that the
trolley cannot slide or tilt with respect to its position on the forks.
7. Lift the
BENOMIC S500
from the ground carefully, and no higher than necessary.
Attention!
-
Secure the BENOMIC S500 to the rack of the forklift truck with a suitable strap!
- Never lift higher than necessary!
- Make sure that the forklift truck is suitable for lifting at least 1500 kg!
- Remove loose parts from the platform before lifting!
- Drive slowly and carefully!
