Berbel BKF 90 iPP, Operating And Installation Instructions

Page: 153 / 164

153
Operation
6006113_a – 01.06.2022
EN
4.7.5 Hob lighting
If the extractor hood is equipped with hob lighting, the
function may be used independent of the fan. Switching on
and off is possible at any time. With activation of the cooking
zone, the hob lighting is also switched on automatically.
☞
Press the slider at the position below the
symbol to switch the hob lighting on or off.
4.7.6 Run-on function
The extractor hood comes with a run-on function. If this
function is used, the extractor hood will operate for a further
10 minutes after it has been switched off.
In recirculated air mode, it is necessary to use the run-
on function so that the extractor hood can remove the
remaining odours. Using the run-on function increases the
life of the filter filling. The filter filling must be replaced at
regular intervals.
The run-on function can be switched on manually or
automatically. The extractor hood is delivered with the
automatic run-on function active, and settings are made
in configuration mode.
Observe the extractor hood instructions.
The extractor hood is switched on, and an
arbitrary power level is selected.
☞ Press the slider at the position below the
symbol.
y
The run-on time (10 minutes) starts in the
power level 1.
y
The button for the active power level
glows.
y
It is possible to switch between the power
levels.
If menu level 2 is selected again, the run-on
function key flashes.
If the minus button is touched again,
the run-on function stops.
4.7.7 Ceiling connection with effect lighting
If the extractor hood is equipped with a ceiling connection
with effect lighting, the lighting may be controlled as follows.
☞ Press the slider at the position below the
symbol to switch the effect lighting of the
ceiling connection on or off.
4.7.8 Extraction mode / recirculated air mode
changeover
If the extractor hood is configured for hybrid mode, it is
possible to switch between extraction mode and recirculated
air mode at any time after activating the changeover
function.
The changeover function is activated in the extractor hood
configuration mode.
Observe the extractor hood instructions.
If the changeover function is activated:
☞
Press the slider at the position below the
symbol.
Button glows dimly:
y
The extractor hood operates in exhaust air
mode.
y
The wall box is opened.
y
The cleaned air is discharged outdoors.
Button glows brightly:
y
The extractor hood operates in recirculated
air mode.
y
The wall box is closed.
y
The cleaned air is discharged into the
room.