Bentone BG 550i M, Installation And Maintenance Instruction

Page: 93 / 148

93
Bentone
Back to the previous curvepoint
-
When the symbol or is no longer highlighted,
press
+
to start calculating curvepoints.
P
V h
min
s %
Bi
ld
1
2
4
/0
7
0
7
When changing from P1 to P2 for the first time, curvepoints P2 … P8
automatically calculated and saved.
CALC appears for a short moment.
!
When reviewing curvepoints after calculating them, check and adjust each
curvepoint in order to achieve good combustion.
Move along to curvepoint (high-fire point)
P9
; allow the burner to reach high-fire point
P9
.
When
P9
flashes, press
ESC
- +
!
If the burner goes into blocking mode when increasing to full load, restart the
setting procedure and adjust the curvepoints in order to avoid the burner entering
blocking mode.
P
V h min s %
Bi
ld
1
2
6
/0
7
0
7
The maximum capacity is displayed.
If the display shows - - - -, the maximum capacity has not yet been
specified.
The system can be run up to 100%.
You can press
/reset
to go to editing mode, enabling you to change the
maximum capacity.
Adjust the setting downwards or upwards using the buttons
-
+
Press
/reset
to save the setting.
Press
ESC
- +
to return to parameter level.
The benefit of setting the maximum input power in this way is that at a
later date it is easy to change the input power without having to adjust the
amount of air and gas. The setting curve is therefore adjusted to the highest
input power that the installation can handle. The desired input power is then
set by entering how much of the maximum power is required.