BENSHAW RSi H2 Series, Instruction Manual

Page: 37 / 49

890053-03-01
890053-
03-00
31
Connecting with Other Products
Attribute ID Access Attribute Name Range Definition
1
value changes from FALSE to
TRUE. (Note2)
13 Get Drive Fault Codes
Refer to the following Drive Fault
Code table (Note2)
15 Get Control From Net.
0
Commands are made using
sources other than the DeviceNet
communication.
➔
Control is from local
1
Commands are made using the
DeviceNet communication as the
source.
➔
Control is from Network
(Note1) Drive Run Inverter operation using Command
Forward Run Cmd. and Reverse Run Cmd.
Run1 Run1 Trigger Event Run Type
0 0 Stop NA
0
→
1 0 Run Run1
0 0
→
1 Run Run2
0
→
1 0
→
1 No Action NA
1 1 No Action NA
1
→
0 1 Run Run2
1 1
→
0 Run Run1
In the table above, Run1 indicates Forward Run Cmd. and Run 2 indicates Reverse
Run Cmd. Commands are made by the EtherNet communication board when the
value changes from 0 (FALSE) to 1 (TRUE). The Forward Run Cmd. value does not
indicate the present operation status of the inverter; it indicates the operation
command value on the EtherNet communication board.
(Note2) Drive Fault
The Drive Fault becomes TRUE when the inverter is faulted.
The Drive Fault Codes for the trips are as follows.
Drive Fault Codes
Fault Code Number Description
0x0000 None
0x1000
Ethermal Out Phase Open InverterOLT
InPhaseOpen ThermalTrip UnderLoad
ParaWriteTrip IOBoardTrip PrePIDFail
OptionTrip1 OptionTrip2 OptionTrip3
LostCommand UNDEFINED LostKeypad