20
111660 Rev C 5-13-14
HOW TO PROGRAM THE DISPENSER FOR OPERATION
Manager’s Access Code Entry - Menu 3
NOTE: Manager’s Mode access is canceled when the Manager’s keypad is un-plugged from the
dispenser. If the Manager’s keypad is removed you must re-enter the Menu Code 3
manager’s access code to re-gain programming access.
NOTE: Some menu codes must be programmed on both Side 1 and Side 2. When programming
is completed for Side 1, be sure to program Side 2.
Access to Menu Codes 4 through 99 is gained by entering a
four digit access code. The software is set with an access
code at the factory of 2218. All dispensers covered in this
manual are shipped with this code. Menu Code 3 must be
used each time the Manager accesses programming for
Menu Codes 4 through 99.
To access the Manager’s Mode, follow this procedure:
1. Press the 3 button and then the
MODE
button on the
Manager’s keypad. The display shown in Figure 3.1
appears.
2. Enter the default number
2218
. Four dashes appear in
the display.
3. Press
the
ENTER
button. When access is gained, the
dashes disappear and the price display appears as in
Figure 3.2. If the dashes do not appear, the access
code entered did not match the code stored in memory.
Press the
CANCEL
button and repeat steps 1, 2, and 3.
4. When access is gained, press the
CANCEL
button to
exit. It is necessary to exit Menu Code 3 before the
remaining protected menus can be accessed. The
display shown in Figure 3.3 appears when the cancel
button is pressed.
How to Change the 4-digit Manager’s Access Code.
A new access code can also be assigned in Menu Code 3.
To assign a new access code, follow this procedure
CAUTION: To avoid having to zero the memory on
the CPU, make sure you record the new access
code exactly as it is programmed into the
dispenser.
1. Press the 3 button and then the
MODE
button on the
keypad.
2. Press the default number
2218 or the previously
stored access code
. Four dashes appear in the
volume display.
Figure 3.1
PASS
CodE
- - 3
Figure 3.2
PASS
CodE
- - 3
Figure 3.3
PASS
SidE
- - 1
How to Program the Dispenser for Operation
