HD-SDI High Speed Dome Camera
10
4. Connect down cover:
Refer to picture 16
，
after taking off M3 screw from upper cover
，
insert the M3 screw into
safety chain of down cover, then screw it.
Picture 16
5. Install All-in-one Camera:
⑴
Pick up camera from carton to check it, then refer to “appendix VI” to set camera baud rate, protocol, and address.
（
Before installing
down cover, take off shield to set DIP, then install shield
）
Note:
If there is something wrong with camera in the process of using, please pack it well, then send it to supplier for repair.
⑵
Unscrew 2 bolts in the picture 1
，
put the screw into hole of key and screw it tightly, then connect IDE26 plug to relevant plug on the
PCB board of camera.
（
refer to 1 7
）
Picture 17
Note
：
When screw down bolt, please hold camera by one hand, operate it by another hand, in case the camera revolve reverse in
the process of screwing. After installing camera
，
please check whether camera can work well under power supply was provided
，
if it can’t work well, please refer to appendix
Ⅹ
.
6. Install down cover:
Loosen the two M4 screws on down cover ring. Apply lubricant to the O-ring to make down cover easier to slip in. Push upward the
down cover into the housing and then fasten down cover with two M4 screws.(refer to picture 18)
Picture18
3).Corner Mount installation
1. Installation Requirements:
Camera with Corner mount is suitable for firm wall which has 90 degree angle between two walls indoor and outdoor
，
Installation
environment as follows
：
⑴
The wall mounting surface must be firm enough to install expansive screws
⑵
The wall mounting surface must be firm enough to bear 4 times the weight of the speed dome
