Getting Started
8-19
System Programming Maintenance
Connecting to a MERLIN MAGIX
Integrated System
8
Direct Local Connection
8
For a direct local connection, you must connect the PC to the system
programming jack. This is the lower modular RS-232 jack on the processor
module, as shown in Figure 6-2. (The upper jack is reserved for the SMDR
printer.)
To connect a PC more than 50 feet from the control unit, see Figure 6-3.
For direct local connections, the system supports speeds of 1,200 and
2,400 bps.
■
If you have multiple modems installed in your system, after clicking
OK, you may be prompted to select the modem you want to connect
with.
■
Clicking CANCEL from the Connection Selection screen causes you
to return to either the Main screen or the First-Time User Wizard,
depending on from where the screen was started.
■
While setting up a Manual Connection, you will also be prompted to
set the Maximum Speed for connection. It is recommended that you
select 2400.
You must use a direct local connection to program in Surrogate mode.
Summary of Contents for Lucent Technologies MERLIN MAGIX
