10. Troubleshooting
43
1
0
. T
roub
leshooting
If the printing quality is still unsatisfactory, you must
manually clean the cartridges:
1
Open the machine and take the cartridges out of
the holder (see also Changing Cartridges). Clean
the contacts (
A
) with a dry, lint-free cloth.
2
Lay a lint-free cloth on a flat surface. Moisten half
the cloth (
A
). Hold the cloth firmly to prevent it
from wrinkling. Place the “nose” (= nozzle side) of
the cartridges against the moistened area (
A
) and
pull the cartridge a single time in the direction in-
dicated by the arrow (
B
) into the dry area (
C
).
Æ
Be sure to hold the cartridge in the correct po-
sition according to the figure above to prevent
damaging the nozzles!
Never touch the nozzles and contacts with bare
fingers and do not shake the cartridges.
Service Codes
With function 83 you can check and configure the fac-
tory settings.
Checking the Firmware Version
The firmware defines the basic functions and capabili-
ties of your multifunction machine.
Check our homepage for information on the current
firmware version that is available for your machine
and update the firmware, if necessary (see section
PC
Functions
/ Using Companion Suite IH / Firmware
Update).
1
Press
MENU/OK
and
83
.
2
Enter the following code using the number keypad:
704100
,
then press
OK
.
3
Use
/
to select
ARE
YOU
SURE: YES
, and
confirm with
OK
. The display shows the current
firmware version of your machine.
²
If you have entered the incorrect code, you
can cancel the entry with
ARE
YOU
SURE:
NO
.
Deactivating the Button
Sounds
Every button press is accompanied by a sound. You can
switch off the button sounds on your machine.
1
Press
MENU/OK
and
83
.
2
Enter the following code using the number keypad:
102300
,
then press
OK
.
3
Use
/
to select
ARE
YOU
SURE: YES
, and con-
firm with
OK
. The button sounds are deactivated.
Follow steps
1
to
3
to reactivate the button tones.
²
If you have entered the incorrect code, you
can cancel the entry with
ARE
YOU
SURE:
NO
.
Restoring the Factory
Settings
Æ
This function deletes all telephone
book entries as well as saved fax and
SMS messages. All settings that have
been changed will be reset to factory set-
tings
. Archive the telephone book with Com-
panion – Address Book or copy the entries to
the Windows address book. Print the saved fax or
SMS messages to prevent loss of data.
1
Unplug the power cord.
2
Press
Y
,
9
and
3
simultaneously.
3
Hold down the buttons while you plug back in the
power cord.
4
Wait
until
erase param
appears on the display
before you let go of the buttons. The machine starts
with the factory settings.
Power Cycling
If a problem occurs that cannot be corrected with the
instructions in this user manual, follow the steps be-
low.
1
Unplug the power cord.
2
Wait at least ten seconds, then plug the power cord
back in.
3
If the same problem continues to occur, please con-
tact our technical customer service or contact your
retailer.
Summary of Contents for Belgafax 710
