Belden grass valley IQH3B Series, User Manual

Page: 65 / 89

65
IQH3B/IQH3BQ
User Manual
Slots 1 to 16
These sections display information about control clients.
Active Front Panels and RollCall PC programs use a RollCall connection to control a module.
RollTrack does not use a connection, it uses Blind Control. Blind Control is the ability to control
a unit without a connection.
• Disconnect: The Disconnect button will disconnect the currently displayed connected
controller.
• Name: This shows the RollCall controller client name/per session. If SNMP is enabled, one
of the session names corresponds to the name of the Gateway unit.
• Connection: This displays the address of the connected controllers. The Show Session
control can be used to scroll through the connected controllers. If SNMP is enabled, then
the Gateway itself will be shown as one of the controllers, usually the first controller. Packet
counts from this controller, and from all connected controllers, are displayed to the right.
• Blind: This will display the address of the last controller to send the module a blind control
packet. Packet counts from blind controllers is shown to the right.
• Allow Blind Control: If the module is to be controlled by Blind Control (RollTrack and
some third party remote control systems), the Allow Blind Control box must be checked.
If Blind Control is not used, Allow Blind Control may be disabled, giving protection against
incorrectly set-up RollTrack sources.
• Single Session Only: When this box is checked, only one connected controller is allowed
to control the module at any one time.
Show Session
This controls which client is displayed by the other Control menu items. Click and drag the
slider to increase or decrease the number of clients displayed.
Note:
When SNMP is enabled, generally the first session displayed is the
current SNMP session to that module.