Belden grass valley IQH3B Series, User Manual

Page: 49 / 89

49
IQH3B/IQH3BQ
User Manual
Module Upgrades
These controls temporarily suppress backplane logging and thumbnailing. They are only used
by RollMechanic and the Control Panel, and do not need to be changed by the user.
• Reset Timer : This resets the timer, used when upgrading a module.
• Enable : Place a check mark in this box to enable the upgrade function.
Power Usage
This displays the maximum ( MAX ) allowable power available for modules.
• IQH3A : 141 Watts
• IQH1A : 63 Watts
• IQH3BQ : 100 Load Units
• IQH3B : 165 Load Units
For example, MAX: 165LU
This field also displays the current power usage ( USED ); the current total of all fitted modules’
power ratings. Values are preceded by OK (if within the maximum) or WARN (if the maximum
is currently exceeded).
For example, USED: OK:71LU or USED : WARN:167LU
Usage values per slot are available for viewing on the Slots pages.
Setup
This group enables control of setup functions.
• Net Show : This function allows a unit to be `hidden' from the network system. When
netshow is active the unit broadcasts its presence.
• Allow Blind Control : If the Gateway is to be controlled by Blind Control, then Allow Blind
Control must be enabled. If Blind Control is not used then Allow Blind Control may be
disabled, giving protection against incorrectly set-up RollTrack sources.
• Where Am I? : This allows the 3U enclosure to be physically located in a large system. When
this function is selected the LED indicator on the front panel of the enclosure will flash red
and green.
Serial Port Setup
Speed
This group allows the serial port to be configured.
The baud rate is set between 2400 and 115200 baud. The default speed for all RollCall serial
connections is 38,400 bps.
Note: If the unit address is changed, Netshow will automatically be
turned on.
Note: If upgrading the Gateway software, Blind Control must be
enabled.
Note: The RollCall PC software only supports speeds up to 57600 baud.