Belanger Signature Series, Owner'S Manual

Page: 57 / 94

INTEGRA® / E-1063
1MANUL102 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681
5-11
Chapter 5 Operator Interface/Wash Setup Screens
Setup
Setup / Loading
Loading Setup 2 (second screen)
•
Minimum After Cars: The system will NOT allow the Dollie up for the next vehicle until the user-defined
Minimum Distance is reached after the vehicle passes through the Photo Eye. Set to zero to disable this
function.
Vehicles can be closer together than this distance since the measurement is taken from the rear
bumper of the lead vehicle to the back of the tire position when Dollie-Up allowed.
•
Drive Up Goof Up: This function toggles back and forth between “Enabled” and “Disabled”. When
ENABLED, system will evaluate if a vehicle has approached without selecting wash. If this is the case, the
vehicle will receive a “Goof Up” wash. It is recommended you set this to disable unless time demonstrates a
need.
•
Timed Goof Up: When selected, if the entrance Photo Eye is broken for the user-selected amount of time
without a vehicle loaded into the QUEUE, a “Goof-Up” wash will be issued. It is recommended you set this to
disable unless time demonstrates a need.
•
Treadle Eval Front: This setting should be enabled at all times except when attended front-pull systems with
Treadle that wish to operate front-pull from Dollie Call only.
•
Disable/Enable – Front Pull, No Treadle: When selected, the front tire dollie comes up when the “Dollie
Call” is pressed. The rear tire Dollie will come up after the user-selected amount of inches after the front
Dollie. The rear tire distance is “FP NO TREADLE BACK TIRE DISTANCE”. (This function can be used if you
are experiencing trouble with the treadle on an attended, Front Tire Pull location).
•
Front Pull No Treadle Back Tire Distance: The distance that will raise rear tire dollie when set in front pull,
No Treadle. Set large enough to get dollie behind largest customers’ rear tire.
•
Rear Push No Treadle: This function toggles back and forth between “Enabled” and “Disabled”. When
ENABLED, the system will NOT evaluate the treadle and each dollie is assumed “Rear Tire”. (This function
can be used if you are experiencing trouble with the Treadle or on a 1-Step, Unattended, Rear Tire Push
system).
•
Auto Size Dollie: This function toggles back and forth between “Enabled” and “Disabled”. When set to
Enabled (Auto), the system will send “Auto Size Dollie” when wash is entered into queue. This option is for “1
Step Loading”.
•
Photo-Eye Standard: Toggles between Photo-Eye Standard and Photo-Eye Always Active. When toggled to
Standard, the Photo-Eye will not be active until a dollie has surfaced and traveled the “Run Way Distance”.
When toggled to Always Active, the Photo-Eye will be active at all times.
See Recommended Initial Settings in Chapter 6 for more information.