Beko BEKOMAT 16 CO, Original Installation And Operation Manual

Page: 23 / 60

6.2 Installation
For assembly work to be carried out, the following prerequisites must be fulfilled and the preparatory tasks must have
been completed.
Prerequisites
Tools Material Protective equipment
• e.g. adjustable spanner • Sealants
• Feed line and discharge line
Always to be worn:
Preparatory tasks
1. Depressurise the compressed gas system or the respective system section and secure it against unintentional
pressure build-up.
2. Note the specified assembly instructions at all times.
Illustration Description / explanation
24
3. Remove the dust cap [24] .
D E
Assembly instructions
• The gradient of the condensate inlet line [D] must be ≥3
%.
• Do not mount any filters in the condensate inlet
line [D] .
• The diameter of the condensate inlet line [D] must be
≥1" (inner diameter ≥22 mm (0.86")).
• Recommended interval:
Equip the condensate inlet line [D] with a shut-off
valve [E] to make simple product maintenance possible.
4. For the condensate inlet line [D] apply sealant to the
end of the pressure-resistant pipe and screw in at the
condensate inlet.
F
G
H
Assembly instructions
• The condensate discharge line [G] may be laid rising
by max. 5 m (17 ft). The minimum pressure required
increases by 0.1 bar (1.5 psi) per metre of incline.
• The diameter of the manifold [H] must be ≥1" and the
gradient ≥3 %.
• Do not use shut-off valves in the condensate discharge.
• Do not kink or block the pressure hose [F] , or route it
across storage or transport areas.
5. For the drain, connect a short pressure hose [F]
(designed for the system pressure) to the condensate
discharge and the condensate discharge line [G] using a
hose clamp.
Original installation and operation manual BEKOMAT
®
16 CO
23 | 60