© BEKA 201
!
9 All rights reserved
BAL2185_Grease_lubrication_pump_PICO_with_PICO-troniX1_-tronic_0519EN 10158410
...a product of
5
2.
General safety instructions
Everybody who is in charge of the assembly, start-up, maintenance and operation of the device must read these
instructions carefully prior to assembly and start-up of the device at the machine! Furthermore, this manual must always
be available at the site of operation!
Basic instructions for setup, operation and maintenance can be found below.
2.1
Safety instructions
Observe the general safety instructions within this key chapter as well as the special safety instructions in other chapters
of this operating and assembly manual.
Warning of electrical voltage.
Safety instructions, which might cause hazards to persons in case of non-observance, are marked with the
general danger symbol.
This symbol warns of hot surfaces.
Warning of suspended loads.
Warning of material damage due to electrostatic discharge! Marks potential risks which may result in material
damage, if not avoided.
This heading is used if improper or general non-observance of the operating and assembly
manual, instructions, specified workflow and the like might result in damage.
This term is used to point out particular details.
Instructions and notes directly attached to the device have to be strictly observed and kept in readable
condition!
2.2
Qualification and training of staff
The staff in charge of operation, maintenance, inspection and assembly have to be qualified accordingly.
Competence, responsibilities and supervision of staff must be clearly defined by the operator. In case the staff
does not have the necessary knowledge it has to be instructed and trained accordingly. The operator is
obliged to ensure that the staff fully understands the contents of this user information.
Caution!
Notice!
