Behncke Control 1.3, Operating Manual

Page: 27 / 60

Control 1.3 Swimming Pool Control Unit
Operation
25

Service level:
If a red line is displayed at the top of the screen, the user is in the service level and has access
to all menu items.
6.4.2 General Settings Menu
6.4.2.1 Querying the System Status
The following control unit statuses can be queried in the “System Status” submenu. If one of the possible
peripheral devices is not set up then its status is also not displayed.

Filter pump status (filter pump)

Backwash valve status (backwashing)

Floor valve status (floor valve)

Solar valve / collector valve status (solar)

Auxiliary heating status (heating)
6.4.2.2 Querying the System Information
The current
software version can be queried under “Version” in the “System Information” submenu as well
as the Internet connection. OK is shown under “Portal XML” when there is an Internet connection.
6.4.2.3 Querying the Balance Values
The following control unit counters ca
n be queried in the “Balance Values” submenu. If one of the possible
peripheral devices is not set up then its balance values are also not displayed.

Entire filter running time in hours (filter)

Filter running time of the system since the last backwashing in hours (filter since filter
backwashing)

Entire running time of the solar heating in hours (solar)

Entire running time of the auxiliary heating in hours (heating)

Entire running time of the fresh water valve in hours (fresh water)

Entire number of filter backwashing cycles (backwashing)

Entire number of rinsing cycles (rinsing)
6.4.2.4 Backwash Protocol
The “Backwash Protocol” submenu lists the following backwashing information:

The date on which the backwashing was triggered

The time at which the backwashing was triggered

The reason for which the backwashing was triggered
6.4.2.5 Messages
The “Messages” submenu lists the following information about the previous fault messages:

The date on which the message appeared

The time at which the message appeared