24
RJ11/POTS Phone Use
Mobile Originating
1.
Lift the RJ11/POTS phone handset “OFF
HOOK” and listen for the dial tone. The call
LED will flash GREEN to indicate the RJ11/
POTS is in use.
2.
Dial (using the full country codes) on the
RJ11/POTS telephone keypad.
3.
Once the call is connected, the POTS STATUS
LED will flash to indicate a call is in progress.
4.
Place the RJ11/POTS phone handset “ON
HOOK” to terminate the call.
Mobile Terminating
1.
The RJ11/POTS phone will sound its ringer.
2.
Lift the RJ11/POTS phone handset “OFF
HOOK” to answer the call.
NOTE: (Default Operation)
For mobile Terminated calls, the call will remain
active for ~90 seconds even if the RJ11/POTS
phone is placed ON HOOK. To end the call
immediately, the other calling party must hang
up (ON HOOK) the call.
Data Use
Ensure that you have installed the BEAM USB
driver – see section “Configuration Settings ”
(shown on page 21).
The TR400/OC400 terminal allows for circuit
switched data via the BEAM USB data port
that is presented when plugged into your PC.
Follow the normal procedures with your data
application to connect. Once connected, the
Call LED will be flashing YELLOW. Once the
circuit switched connection has ended, the
Call LED will turn off.
NOTE: During a Data connection, the RJ11/POTS
handset cannot make or receive voice calls. An
unavailable tone will be heard on the RJ11/
POTS handset.
Call Processing on RJ11/POTS Phone
Call processing is the ability for the terminal
to automatically prefix a users dialled number
with the correct area or country code. This is
intended to allow for a simpler dialling process
for users who have not been trained to place a
call from a satellite phone.
The Falcon Configuration Tool will allow users
to enable or disable this feature. By default this
feature will be disabled.
When this feature is disabled there will be no
alteration to dialled numbers on the
RJ11/POTS Phone.
When call processing is enabled the user will be
able to customise the following parameters:
•
Minimum Digits
•
Country Code
•
Area Code
•
Leading Digit for Information numbers
•
Leading Digit for Long Distance (STD)
•
Dialling Emergency number
•
Dialling Voicemail number
•
QUICK DIAL
•
ENABLE AUTO DIAL
For further details on these parameters, consult
the Falcon Configuration Tool Manual.
Summary of Contents for Oceana 400
Page 1: ...Terra 400 User Manual ...
Page 27: ...28 Physical Dimensions TR400 OC400 190mm 100mm 65mm 53mm 240mm ...
Page 30: ......
