Beam Oceana 400, User Manual

Page: 15 / 31

16
WARNING
DO NOT pull with force on the cables from the rear
of the TR400/OC400. Please install strain relief
clamping for the antenna cables where required.
Correct installation of the antenna system is a
vital part of the TR400/OC400 terminal, to ensure
reliable functionality, and drop-free calls.
WARNING
Changes or modifications not expressly approved
by BEAM Communications could void the user’s
authority to operate the equipment.
WARNING
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of
55cm or more should be maintained between the
antenna of this device and persons during device
operation. To ensure compliance, operations at
closer than this distance is not recommended.
Anntena Connection Diagram for OC400
Maritime Antenna (Active)
NOTE
Refer to the section “Quality of Service” page 26,
for more information on antenna placement and
installation. Only BEAM approved antenna cables
should be used with all terminals and antennas.
ISD710
Maritime Antenna
(Active)
For use with OC400
ISD700
Fixed/Directional
Antenna (Passive)
For use with TR400
5 4
3 2
TNC
SMA
SMA
SMA
Satellite
Antenna
Cable
GPS
Antenna
Cable