19 November 2008
BD X-Monitor 2 #
1080500
20
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: #88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
wiring harness to receive an accurate reading. Only tap the wire of the plug that is
going to the sensor. Tapping the factory wire when using a power module will result
in a false reading.
7. Connect the blue wire to the wire tap.
8. Locate the Engine Oil Temperature Sensor (EOT) towards the front of the engine.
This is a 2-wire connector located on the top of the engine just behind the High
Pressure Oil reservoir. The sensor will be mounted horizontal to the truck.
Note: On
the 7.3L engines we monitor the oil
temperature instead of coolant
temperature. This will cause the
temperatures to be slightly higher than
water and you should adjust your
warnings and warm-up module
accordingly.
9. Connect the supplied wire tap to pin
#2. If you are holding the connector
with the clip release facing up and
looking at the back side where the wires enter the connector, then the correct wire
should be on the left side.
10. Connect the orange wire to the wire tap.
11. Locate the high pressure test port on your transmission. This port is on the driver’s
side of the vehicle. There is a
small plug in the test port.
Remove the plug.
12. Using Teflon tape, screw the
temperature probe and fittings into
the test port. Do not over tighten.
13. Route the purple wire from the
wiring harness to the temperature
sensor.
14. Remove the nut and washers from the sensor and install the purple wire. Replace
the washers and tighten the nut to secure the wire.
15. Go over the wiring harness and secure it to the vehicle out of harms way using the
supplied wire ties. Keep all wires far away from any moving or hot parts.
