19 November 2008
BD X-Monitor 2 #
1080500
17
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: #88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Optional Ram Fuel Pressure Monitoring Kit #1080150
With the X2 Monitor you can also monitor the auxiliary fuel pressure as well as the rail
pressure on your Dodge Common Rail engine (2003-06). If you have a 1999.5 to 2002
Dodge you can utilize the auxiliary fuel pressure sensor only and not the rail pressure
sensor. For the connections you do not reuse, you should zip tie them out of the way.
Rail Pressure Sensor (3
rd
Gen Dodge Only 2003-06)
On the top of the intake to the engine on the driver’s side you will need to locate the rail
pressure sensor. This sensor is a three wire type.
Use the supplied scotk-lok and connect to Pin # 2 or the center wire. With the scotk-lok
connected, then connect the green wire with the male spade connector from the wiring
harness to it.
Auxiliary Fuel Pressure
First you will need to install the supplied banjo bolt and the new sealing washers into the
intake of either the VP44 or CP3. Make sure that you install it into the supply line (larger
line) and not the return line (smaller line). Once the banjo is installed you can install the
fuel pressure sender into the banjo bolt. The thread is 1/8NPT so you will want to snug
the connection up otherwise it will leak. We advise against using Teflon tap as it there is
no filter between this connection and your injection pump. Once this connection is made
you can then attach the ring terminal/yellow wire of the harness.
