19 November 2008
BD X-Monitor 2 #
1080500
14
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: #88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
16. Using Teflon tape, screw the temperature probe and fittings into the test port. Do
not over tighten.
17. Route the purple wire from the wiring harness to the temperature sensor.
18. Remove the nut and washers from the sensor and install the purple wire. Replace
the washers and tighten the nut to secure the wire.
19. Go over the wiring harness and secure it to the vehicle, out of harms way using the
supplied wire ties. Keep all wires as far away from moving parts and hot parts as
possible.
20. Slide the green plug through the rubber grommet where you ran the lead wire. Pull
enough of the wire harness inside the cab so that the switch port connection (white
and black wires) and the black wire with the ring terminal are inside the cabin.
21. Find the bolt located by the firewall and remove it. Place the bolt through the ring
terminal of the black wire and screw it back into its location.
22. In the engine compartment, locate the red wire with the installed fuse tap.
23. Open the fuse box located under the hood on the driver’s side fender.
24. Remove fuse #28 and install the fuse tap over the leg of the fuse. Re-install the
fuse.
25. Once everything is secure and installed you will want to start your engine. The X2
comes pre-set for these 4 parameters. To make sure everything is installed
correctly, use these basic guidelines:
EGT temperatures should be in the 250-350°F (120-175°C) ranges, depending on
engine temperature and outside temperature. Boost pressure should read 0psi at
idle and up to 5psi while revving the engine at the idle position. ECT should be
similar to your factory gauge. If the vehicle is cold, it should read close to ambient
temperature and slowly rise.
Transmission temperature will most likely read ~100°F (35°C). It can take up to 20
miles, depending on the outside temperature, driving style and load to reach
temperatures above 100°F (35°C). Operating temperatures range from 110-180°F
(40-80°C) dependant upon load and driving style.
26. Using the supplied wire ties, tie up the wire and cable harness under the dash.
