Page
16
Route
Setup
Processes
UnitInfo
Database
NETWORK
CONFIGURATION
MENU:
Select 6),
Every TCP/IP client machine, regardless of operating system, needs to make decisions about
where to send a packet after it has been addressed. The route table is the network map that tells your
Baytech product how to deliver the packet to its network addressee.
Destination
is a list of routes. “0” represents any number.
Gateway
is the network gateway for the route. The connection point to your company network.
Genmask
defines how closely an address must match the network destination, octet by octet, to
use the route.
Iface
interface used to reach the network gateway, in this case Baytech network card.
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
Press ENTER to continue
Select 7),
to see a list of Process commands
used by the firmware to operate.
Type
“T”
, and the unit will prompt for a PID number to terminate:
PID PORT STAT SIZE SHARED %CPU COMMAND
1 S 133K 0K 0.2 init
2 S 0K 0K 0.0 keventd
6 S 0K 0K 0.0 kupdated
11 R 43K 0K 99.3 baytechd
12 S 13K 0K 0.1 mdmautologind
13 S0 S 13K 0K 0.1 /bin/autologind
14 S 14K 0K 0.0 /bin/inetd
17 S 133K 0K 0.1 rpccmdd
18 S 13K 0K 0.0 snmppolld
19 S 1833K 0K 0.0 snmpd
25 S0 R 71K 0K 1.0 ds62
Strike T, CR to terminate a connection/process,
CR to continue :
Enter PID process to terminate, CR:
IMPORTANT:
If a process is
terminated, the functionality of the unit
unitInfo->portUser 0
unitInfo->cfgUser 0
unitInfo->connState 0
unitInfo->connPid 0
unitInfo->buildUserTableFlag 0
unitInfo->kill_poller 0
unitInfo->background_polling=0
bcTable->connAttempt=0
maybe interrupted. To reestablish the
unit’s functionality, power the unit off
than on.
NOTE:
The following message, “
Configuration mode in use
”, signifies a user in the other port is
in the “Configuration” menu.
1
st
level of configuration identifies all
modules connected to the DS-chassis. The
Ds74 has the (4) serial ports. May have more
than one DS74 listed. DS-RPC is the chassis
(4) power ports
Configuration
DS62 module #1...1
DS74 module #2...2
DS-RPC module #3...3
DS-RPC Chassis ONLY
