[email protected] - www.bay-tec.de 17
Read
After selecting the port, connect the controller to the USB adapter and wait until the initialization is done. Click
“Read” to read the settings to the software from the controller. After a successful reading, you can see the current
firmware version and data version of the controller in the lower-right corner of the form.
VERY IMPORTANT!
1
．
Please wait until the initialization is finished before you operating the software.
2
．
The firmware version number of the program card and the config software are corresponding to the Data
Version that the controller is using. That means you don’t need to upgrade the program card or the
software if the data version number doesn’t change even if you have upgraded the firmware of the
controller.
Write
After making your change of the settings, click “Write” to save the modified settings into the controller. The new
settings will take effect immediately.
Firmware Update
VERY IMPORTANT!
1
．
Both the controller and the card can be upgraded online.
2
．
We use a boot loader to enter the update program on our products. Please don’t power the controller or
the card before update.
3
．
You don’t need to remove the controller from your plane, or disconnect the servos and receiver from the
controller during a firmware update operation.
4
．
The update wizard needs to get the available firmware list from the server, please make sure your computer
is connected to the internet.
