Bay Networks Remote Annex 2000, Hardware Installation Manual, Page: 86 / 136

Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-28
sequence
The sequence command edits the load/dump interface list. This list
determines the order of the network interfaces, and either the local
area network (LAN) or the SLIP interface the Remote Annex 2000 will
use for loading and dumping. The default, net, uses the LAN
interface. The list can contain up to four interfaces. If the Remote
Annex 2000 fails to boot using the first interface, it will try the next,
and then the next interface, and then repeat the sequence. The
command syntax is:
sequence [–d] | [interface[,interface]. . .]
Specify the LAN interface by selecting net; specify each SLIP interface
as slnn, where nn is a port number; and specify self-boot by selecting
self
. Separate each interface with a comma or a space. Enter the
interface list as an argument to the command; otherwise, the console
displays a list of available interfaces and prompts for a new list.
In the following example, interfaces are assigned to the load/dump
sequence list. Ports 12, 14, and 15 can be added to the list because they
were configured earlier as SLIP interfaces:
The SELF option appears only if the self-boot image is loaded.
monitor:: sequence
Enter a list of 1 to 4 interfaces to attempt to use for
downloading code or upline dumping. Enter them in the order
they should be tried, separated by commas or spaces.
Possible interfaces are:
Ethernet: net
SL/IP:sl12,sl14,sl15
SELF: self
Enter interface sequence [net]:: sl12, net
Interface sequence: sl12,net
W
ARNING