Bay Networks Remote Annex 2000, Hardware Installation Manual, Page: 107 / 136

4-15 Remote Annex 2000 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Unless otherwise stated, if you are using a SLIP interface to boot the
Remote Annex 2000, obtain the following information using the slip
command:
❑
Whether the port is configured as a SLIP interface.
❑
The default IP address for the SLIP network interface.
❑
The default IP address for the remote end of the SLIP
connection.
❑
The default IP address for the load/dump host (this must be
specified if the remote end is a gateway and not a load host).
❑
Whether the SLIP network interface is included in the load/
dump interface list (use the sequence command).
❑
The baud rate.
❑
The number of stop bits.
❑
The parity.
You can use the defaults for both the name of the image file containing
the Remote Annex 2000’s software and the address of the preferred
load server host. If the value for the image name is incorrect, the
Remote Annex 2000 cannot boot. Correct the name using the image
command. If the address for the preferred load server host is incorrect,
the boot takes longer, since the Remote Annex 2000 has to broadcast
for a host. Correct the load host’s address using the addr command.
Confirm that the Remote Annex 2000 boot parameters are correct by
using the appropriate ROM Monitor commands. Modify any boot
parameters that are incorrect or missing. Boot the Remote Annex 2000
either by entering the boot command at the console, or by holding
down the
button until the Power LED blinks rapidly and then
releasing the button.
Test
Test