Baxi CBP Matic 18, Manual

Page: 171 / 249

8
4. Installation of the pellet-run boiler
Before installing, please perform the following steps:

Upon reception, check the product for completeness and to determine that is
does not show any damage signs. Any damages or defects should be checked
before the unit is installed.

The unit is equipped with four height adjustable feet at its base, allowing for
simple adjustments when installing on non-flat surfaces.
Figure 3
– Adjustable feet

Remove the instruction manual from the package and hand it over to the client.

Connect a 100 mm diameter pipe between the boiler's combustion gases output
and the fume extraction pipe leading out of the building (e.g. through the chimney)
– please check diagrams in point 4.

If a tube is used for combustion air inlet from the outside, it shall be no longer
than 60cm horizontally or present offsets (such as bends);

Carry out the hydraulic installation (please consult point 4.5)

Connectthe 230 VAC power cable to an grounded socket.

The unit's remote control has a programmable thermostat. Optionally, a
conventional external programmer may be used (not included) to automatically
define the unit's operating periods.