3.
Place a type “A” coal between the
front and rear base coals with the
letter “A” upright and so that the coal
is against the left side of the firebox
(See figure 31).
4.
Place a type “B” coal between the
front and rear base coals as shown in
figure 32. The letter “B” should be
upright.
5.
Place a type “A” coal between
the front and rear base coals with
the letter “A” upright. The top of
the coal should rest against the
centre coal of the rear base coal as
shown in figure 33.
6.
Place the remaining type “B” coal
at the right side of the firebox
between the front and rear base coals.
The letter “B” should be upright. The
coal should touch the right side of the
firebox. See figure 34.
7.
Place the remaining type “A”
coal between the front and rear
base coals. The letter “A” should
be upside down with its rear face
between the right and centre coals
of the rear base coal. Angle the
coal so that the gap between it and
the type “B” coal to its right is
appreciably larger than the gap
between it and the type “A” coal to its
left but do not have it touching the
type “A” coal. This will give the best
flame effect (See figure 35).
Page 27
INSTALLER GUIDE
Figure 35.
Figure 34.
Figure 33
.
Figure 32.
Figure 31.
