Page 18
INSTALLER GUIDE
8. PREPARING APPLIANCE FOR INSTALLATION
8.1 Appliance preparation.
1.
Remove any transit tape and packing and
inspect for any evidence of mishandling which
might affect the performance of the fire. Each
unit is flame tested before it leaves the factory
and as a result there may be slight
discolouration around the burner ports.
2.
Detach the burner unit from the hotbox by
removing two screws (See figure 8). Lift the
burner unit clear.
IMPORTANT
Before continuing with the installation of this
gas fire the aeration setting on the burner
must be checked. The aeration is factory set,
but will require adjustment (See section 17.1).
3.
It is important that the grommet ‘H’ supplied in
the loose parts pack is fitted to the hole in the rear
of the hotbox.
8.2 Fitting the ‘push on’ fascia trim for the
Blenheim, Sonnet, Homeflame Traditional,
Anthem, Debut, Aura 2 & Minima models.
1.
The fascia is supplied in three pieces. Remove any protective film. The two longer
pieces are the left and right sides. The shorter piece is the top. The left and right hand
pieces have folded edges, one of which is shorter than the other. This shortened edge
should be fitted at the inner top on both sides. Fit the top piece last and centralise (See
figure 9).
8.3 Fitting the foam seal (All models).
There is a length of self adhesive foam seal supplied with the fire. This will need to be
fitted to the outer rear edges of the side and top flanges of the hotbox. If the fire is fitted
with ‘push on’ style fascia trim as in 8.2 above the foam seal will be fitted over the
flanges of the fascia.
It is therefore important to ensure that the fascia is positioned
correctly before fitting the foam seal.
Cut the foam seal to the required length. Be
careful not to stretch the seal when measuring. Remove the protective backing from the
foam seal and fit this to the rear of the hotbox flange (See figure 10).
Figure 9. Fitting the fascia
Figure 8. Burner attachment points
