14.2 Fitting the Quantum fascia.
1.
Place the fascia on top of the plinth. Be careful
not to drag the fascia across the top surface of the
plinth as this will scratch the plinth. Secure the
fascia to the plinth using the two ‘D’ screws
supplied (See Figure 53).
2.
Fit the fascia to the appliance by locating the
top to the upper hanging bracket (Figure 54),
then attaching it to the body of the appliance
using the two ‘C’
screws supplied
(Figure 53)
3.
Fit the firefront
trim to the fascia
(Figure 55).
14.3 Fitting the Camden, Fusion and Coast
fascia trim.
1.
The fascia is supplied in three pieces.
Carefully remove the three pieces from the
packaging. Remove any protective film.
2.
The magnets used to locate each trim
should already be positioned on the rear of
each trim. Each trim should have two
magnets. If the magnets are not fitted then
locate one magnet centrally at each end of the
trims.
3.
Locate the side trims as in figure 56.
4.
Locate the top trim as in figure 56.
Page 34
INSTALLER GUIDE
Figure 56. Fitting the fascia
Figure 55. Fitting the
Quantum firefront trim
Figure 54. Fitting the
Quantum fascia
Figure 53.
