Responsibility and liability
Operating Instructions Option Module IEI for b maXX drive PLC BM4-O-IEI-01
Document No.: 5.02013.02
Baumüller Nürnberg GmbH
14
2.9
.
2.9.2
Danger arising from using this module
The incremental encoder interface has been developed and manufactured to the state of
the art and complies with applicable guidelines and standards. It is still possible that haz-
ards can arise during use. For an overview of possible hazards, refer to the chapter enti-
tled
from page 7 onward and to
We will also warn you of acute hazards at the appropriate locations in this documentation.
2.9.3
Warranty and Liability
All the information in this documentation is non-binding customer information; it is subject
to ongoing further development and is updated on a continuous basis by our permanent
change management system.
Warranty and liability claims against Baumüller Nürnberg GmbH are excluded; this ap-
plies in particular if one or more of the causes listed in
12 onward or below caused the fault:
m
Disaster due to the influence of foreign bodies or force majeure.
WARNING
The following
may occur
,
if you do not observe this warning information:
m
serious personal injury
m
death
Any and all persons who work on and with Series b maXX units must always have available
these Operating Instructions and must observe the instructions and information they contain
– this applies in particular to the safety instructions.
Apart from this, any and all persons who work on this unit must be familiar with and observe
all the rules and regulations that apply at the place of use.