Bartscher IK 27TC, Manual

Page: 40 / 304

- 36 -
6.3 Operation
•
Before the device operation clean it according to the instructions in section 7
“Cleaning”
.
CAUTION!
Never place an empty cookware on the hob.
Warming up an empty pot or frying pan activates the overheaeting protection
system; an audio signal will sound (3 times) and the device turns off.
„E2“ error code will appear on the display.
Remove the pot from the hob and leave the device for a few minutes to
cool off. Then, you may start using the device again.
•
Place an appropriate cookwate with food in the middle of the hob.
•
Connect the device to a single grounded outlet.
An audio signal wil sound and the ON indicator light will start blinking.
The device is in the STANDBY mode now .
•
To switch the device on, press the ON/OFF button .
The digital display shows “---”.
Settings
Power mode
•
Press the button , to directly switch to the power mode. Factory set power value
of 1500 W will be displayed.
The power mode indicator light ( ) will come on.
•
The buttons and may be used at any moment to change settings in this respect
500 W - 2700 W . The digital display shows the corresponding power.
The following power level can be set:
1 - 500 W, 2 - 800 W, 3 - 1000 W, 4 - 1300 W, 5 - 1500 W,
6- 1800 W, 7 - 2000 W, 8 - 2300 W, 9 - 2500 W, 10 - 2700 W )
Temperature mode
•
To leave the power mode, press the function key (for power or
temperature mode) switching to the temperature mode.
•
The device switches to the factory-set temperature of 100 °C which appears on
the digital display.
The temperature mode indicator light ( ) will come on.