Barton 99809, Owner'S Manual And Safety Instructions

Page: 8 / 20

INSTALLATION INSTALLATION
STEP 1. The quick connection adaptor is primarily for quick connection to a single faucet, such as a kitchen
sink. Skip this step if you are connecting the washer to a sink with separate hot and cold faucets the adaptor
consists of two parts that quickly connect or disconnect. One part, the faucet fitting, is for connection to the
faucet and the other part, the hose fitting, connects to the cold water hose of the washer.
Pull back on the white ring to free the faucet fitting from the adaptor for installation into the faucet.
Screw the end of the cold water hose onto the base of the hose fitting.
If the faucet has internal screw threads, unscrew the aerator if present from the tip of the faucet. Then
screw the faucet fitting into the faucet. Make sure the black rubber gasket is on top of the adaptor before
screwing it in.
If the faucet has external screw threads, remove the gasket from the top of the faucet fitting and screw
the fitting over the external threads.
Pull back on the white ring to connect the two parts of the adaptor back together.
NOTE: When connected to a single faucet that can dispense either hot or cold water, both hot and cold
water can be run through the cold water line for washing use. However, it is recommended to only run cold
water washes when the adaptor is connected to such a faucet.
STEP 2. Connect the ends of the water supply hoses to the HOT and COLD faucets. For convenience, use
the quick connection adaptor for connection to the cold water faucet.
STEP 3. Tighten the fittings by hand until they are snug, then tighten them an additional 2/3 of a turn with a
wrench.
When you fasten the fittings, do not fasten them too tightly or apply tape or sealant to the faucets or water
supply intakes. This can damage the fittings. After you have connected the water supply hoses to the
faucets, ensure that they are connected securely by pulling the water supply hoses downwards.
STEP 4. Place the unconnected ends of the hoses into a bucket and open the faucets
connected to the two water supply hoses for 10-15 seconds to remove any foreign
substances from the hoses. Close the faucets before continuing.
STEP 5. Connect the ends of the water supply hoses to the water supply intake connections at the back of
the washer.
The water supply hose connected to the HOT faucet
must be connected to the hot water supply intake and
the water supply connected to the COLD faucet must
be connected to the cold water supply intake.
7