Barton 99809, Owner'S Manual And Safety Instructions

Page: 10 / 20

OPERATION OPERATION
POWERING YOUR WASHER
1. Plug the power cord into a 3-prong, well grounded 120V/60Hz approved outlet protected by a 15 AMP fuse
or comparable circuit breaker
RUNNING A TEST CYCLE
1. Load about 6lbs of laundry into the tub. Then press the POWER button to turn on your washer.
2. Press the POWER button to turn on your washer.
3. Select the RINSE + SPIN cycle by pressing the FUNCTION to turn ON the RINSE and SPIN lights.
4.
Press the
START/PAUSE
button to start the test cycle.
5. The washer should not rock or vibrate excessively when the water is supplied or when washing or spinning
and should drain well during the spin cycle.
If water leaks while water is being supplied or drained, check the water connections, If the washer rocks and
vibrates excessively, level your washer again.
STORING YOUR WASHER
If you want to store your washer at another location, unplug it, drain any remaining water from the drain pipe
and hook the pipe onto the back of the washer. Disconnect the water inlet hoses from the faucets and move
the washer to a new location.
CONTROL PANEL
POWER: Press the POWER button once to turn on the power of the washer. Press
again to turn off the unit.
START/PAUSE: Press the START/PAUSE button once to start the wash cycle. Press
the button during operation to pause the cycle. Press again to continue the cycle.
PROGRAM: Press this button to select the desired washing program.
9