Barton 99809, Owner'S Manual And Safety Instructions

Page: 9 / 20

INSTALLATION
Confirm that the water supply hoses are not twisted or bent. If the hoses are twisted or bent, the hoses can
leak and cause electric shock due to the water leakage. To ensure the correct water usage, connect both the
HOT and COLD water faucets. If wither or both are not connected, an error code can occur. If you do not want
to use the HOT water supply hose, install the water intake cap into the HOT water supply intake hole. In this
case, you must select cold water as the wash temperature option.
STEP 6. Tighten the fittings by hand until they are snug, then tighten them an additional 2/3 of a turn with a
wrench.
STEP 7. Turn on the HOT and COLD water supplies and check all the water supply intake connections and
the faucets for water leaks.
CONNECT THE DRAIN HOSE
Position the other end of the drain hose. It can be positioned in three
ways.
A.
Over the edge of the basin. Secure the guide to the side of the
basin wall with a hook or to the tap with a piece of string to prevent the
drain hose from moving.
B. In a standpipe. The standpipe must be no shorter than 32” and no
longer than 39”.
C.
In a laundry tub, The laundry tub must be no shorter than 32” and
no higher than 39”.
NOTE: Make sure the connection between the drain hose and the
wash basin, standpipe or laundry tub is not airtight.
LEVELLING YOUR WASHER
1.
Slide the washer into position, then open the lid of the washer and
pour the water into the tub to just below the pulsator level.
2.
If the washer is level, the pulsator is positioned at the center of the
washer as shown. If not, level your washer by turning the front leveling
feet clockwise or counter-clockwise as necessary.
8