Barton 99809, Owner'S Manual And Safety Instructions

Page: 7 / 20

6
INSTALLATION
WATER
To correctly fill your washer in the proper amount of time. Water pressure of 14 to 70PSI (100 to 500 kPa) is
required. Water pressure less than 14psi may cause water valve failure, or may not allow the water valve to
shot off completely or can extend the fill time beyond what your washer controls allow, causing your washer
to turn off and alarm error. A time limit is built into the controls to prevent flooding in your home if a hose
becomes loose. The water faucet must be within 4 feet (122cm) of the back of your washer. To avoid the
possibility of water damage, have the water faucets easily accessible. Turn off faucets when washer is not
in use. Periodically check that there is no leakage from the water inlet fittings.
DRAIN FACILITY: The recommended height of the standpipe is 35” or 90cm. The drain hose must be
routed through the drain hose clip to the standpipe. The standpipe must be large enough to accept the
outside diameter of the drain hose.
INSTALLING THE WASHER
STEP 1. Tilt the unit back onto its rear rollers and push it forward as shown. Move the unit to a location as
described in the previous location section. Make sure the surface is level and without carpeting.
STEP 2. Slide the bottom cover into the slots on the bottom surface of the unit as in the following figure and
fix it with two screws attached with the unit.