Mobile Computer
MC 9190
ex
-NI
Type B7-A28.-…………
Maintenance, Inspection,
Repair
Technical data subject to change without notice.
Issue: Revision 2 / August 2012
Page 41 of 50
8
Maintenance, Inspection, Repair
This chapter describes cleaning and storing the MC 9190
ex
-NI, as well as possible
procedures when problems occur while using the MC 9190
ex
-NI.
Caution!
When doing maintenance or servicing or when checking associated equipment, comply
with the applicable regulations in accordance with directives IEC 60079-19 and
IEC 60079-17!
Installation/dismantling, operating and maintenance work may be carried out by trained
specialists only. Statutory regulations and other binding directives on workplace safety,
accident prevention and environmental protection must be adhered to.
You should heed the following tips when using the MC 9190
ex
-NI to guarantee fault-free
operation:
−
Pay attention that the MC 9190
ex
-NI display is not scratched. When working with the
MC 9190
ex
-NI use the supplied stylus or pens with plastic tip which are designed for
use with touch screens. Never use a ballpoint pen, pencils or other pointed items on
the MC 9190
ex
-NI screen. BARTEC recommends using a screen protector, Part no.
17-A1Z0-0003.
−
The touch-sensitive screen of the MC 9190
ex
-NI contains glass. Take care not to drop
the MC 9190
ex
-NI or subject it to strong impact.
−
Protect the MC9190
ex
-NI against extreme temperatures. Do not leave it on the
dashboard of the car on hot days and keep it away from heat sources.
−
Do not store the MC 9190
ex
-NI in dusty, moist or wet environments.
−
Use a soft spectacle cleaning cloth to clean the MC 9190
ex
-NI. If the MC 9190
ex
-NI
display surface is dirty, clean it with a soft spectacle cleaning cloth soaked in diluted
window cleaner.
−
Change the re-chargeable battery regularly to ensure maximum battery life and
equipment performance. Battery life depends on the individual usage pattern. The
battery provides a state display to estimate the remaining life. You can find further
information in chapter 4.4 “Battery”.
−
Pay attention that the scan window is not scratched. Clean the window regularly.
Dust, contaminants and scratches on the scan window can lead to visible spots on
the pictures taken with the scanner.
−
The battery should be completely charged before it is used for the first time. Note that
the maximum capacity of the battery is not attained until after approx. 5-6 charging
and discharging cycles.
−
For the MC 9190
ex
-NI is a screen protector available. BARTEC recommends using
this, to avoid wear marks. A screen protector contributes to the user friendliness of
the equipment and protects the touch screen.
